cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
295
Views
5
Helpful
3
Replies

Cisco 3802i mobilty express for AP on a stick site survey

Hi all,

 

Got a 3802i (8.3.102.0) and want to use it as an access-point to do site-survey.

I went through the document and got stuck in the below process

Step 7   To configure channel, TX power, and channel bandwidth for the radios, disable the radio first, make the changes and then re-enable it.

To change the 2.4GHz radio to channel 6, follow the steps below:

(Cisco Controller)>config 802.11b disable <ap name>
(Cisco Controller)>config 802.11b channel <ap name> <ap name> 6 
(Cisco Controller)>config 802.11b enable <ap name>

To change the 2.4GHz radio Transmit Power to power level 3, follow the steps below:

(Cisco Controller)>config 802.11b disable <ap name>
(Cisco Controller)>config 802.11b txPower <ap name> <ap name> 3 
(Cisco Controller)>config 802.11b enable <ap name>

To change the 5 GHz radio to channel 44, follow the steps below:

(Cisco Controller)>config 802.11a disable <ap name>
(Cisco Controller)>config 802.11a channel <ap name> <ap name> 44 
(Cisco Controller)>config 802.11a enable <ap name>
To change the 5 GHz radio Transmit Power to level 5, follow the steps below:
(Cisco Controller)>config 802.11a disable <ap name>
(Cisco Controller)>config 802.11a txPower <ap name> <ap name> 5 
(Cisco Controller)>config 802.11a enable <ap name>
To change the 5 GHz radio channel width to 40MHz, follow the steps below:
(Cisco Controller)>config 802.11a disable <ap name>
(Cisco Controller)>config 802.11a chan_width <ap name> 40 
(Cisco Controller)>config 802.11a enable <ap name>
   

the mobility express wlc doesnt recognize itself as an ap. Can this be achieved? 3802i acting as WLC and AP servicing clients (FAQ says yes) any help is appreciated.

I also keep getting the error message

Config not synced to APs since no AP is present

 

regards

3 REPLIES 3
Highlighted
Rising star

Re: Cisco 3802i mobilty express for AP on a stick site survey

I guess you are following the document Configuring Mobility Express for Site Survey using CLI

let's check

The following APs support sitesurvey capability

- AccessPoints – 3800 Series AireOS Release 8.3.111.0 and later 

=> guess you need to start with an upgrade

 

 

Re: Cisco 3802i mobilty express for AP on a stick site survey

I should have been blind to miss that one. Thanks for that.

 

cheers

 

Re: Cisco 3802i mobilty express for AP on a stick site survey

for some reason the tftp upgrade fails saying incorrect tar file. I tried to upgrade to 8.5 and 8.8 both same problem.

when i keep the same image (8.3.102) and try to configure the master ap (using apciscoshell command from controller mode) it registers but capwap tunnel drops every 10 seconds and clients gets disconnected.

 

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards