ā09-10-2024 01:56 AM
Hi I Have cisco 4321 model fail to load IOS, as I get below errors. Kindly assist
ā09-10-2024 02:05 AM
What firmware is the router meant to boot up to, is it 17.12.X (and later)?
ā09-10-2024 02:22 AM
firmware is 17.6.2
ā09-10-2024 02:41 AM
Change the baud rate of the console port.
ā09-10-2024 03:22 AM
Thanks @Leo Laohoo issue sorted
ā09-10-2024 02:52 AM
Specifically what baud rate should I set ?
ā09-10-2024 03:02 AM
Start with the highest and adjust it until the letters are readable.
ā09-10-2024 03:26 AM
Yes I did that until 19200 then letters start to read.
ā09-11-2024 02:43 PM
Glad you solved it. Thanks for sharing the solution.
Not sure why someone changed the speed of the console, and then only increased it by a little bit. But that obviously is what happened. Now that you have solved the issue you could maintain the current setting. But I would suggest that you change the console speed to the default value, which might help the next person in your position to not have the same problem again.
ā09-10-2024 03:06 AM
Baud should be 9600. Why does is fail to boot? What does the console output display when you set the baud to 9600?
BR
ā09-10-2024 03:07 AM
Hi @Leo Laohoo This is super issue sorted
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide