08-03-2017 02:54 PM - edited 03-05-2019 08:56 AM
Hi,
Can the management port on Router 4331 be used as a normal port for circuit connection etc?
Thanks!
08-03-2017 03:22 PM
short answer, no
The router provides an Ethernet management port named GigabitEthernet0.
The Ethernet management port allows you to perform management tasks on the router. It is an interface that should not, and often cannot, forward network traffic, but can be used to access the router via Telnet and Secure Shell (SSH) to perform management tasks on the router. The interface is most useful before a router has begun routing, or in troubleshooting scenarios when other forwarding interfaces are inactive.
08-03-2017 03:45 PM
Thank you for your reply!
So it also can't be used for connecting to secondary router (HSRP)?
08-04-2017 07:47 AM
By default, probably not.
If it could be configured as a "normal" port (which is a big if), you're may also find it offers very little capacity and any substantial traffic on the port might overload the router.
08-04-2017 07:44 PM
Thank you!
08-04-2017 07:45 PM
Thank you!
08-03-2017 04:02 PM
You might get it to work, but given the caveats above (straight from the 4331 doc) why risk it?
I doubt if the TAC would be much help if you did.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide