cisco 4948 switch

[syed baseeruddin]

Hi

when i start the switch 4948 and access via console the switch4948  is  directly going in rommon 1 >

[Ashok Kumar]

Hi,

please log the booting process in a file & paste here to check the exact reason, generally it happens when device don't have any IOS file or IOS file is corrupt or somehow device not able to load the IOS in the DRAM.

 
- Ashok

************************************************************************************************************

Please rate the useful post or mark as correct answer as it will help others looking for similar information

************************************************************************************************************

[syed baseeruddin]

Hi

Thanks for your reply

when i apply this commands  configreg 

rommon 1 >set
 PS1=rommon ! >
 Fa1Enable=1
 RommonVer=12.2(31r)SGA2
 DebugCallHome=00000
 BOOTLDR=bootflash:cat4500-entservicesk9-mz.150-2.SG4.bin
 BootedFileName=bootflash:cat4500-entservicesk9-mz.150-2.SG4.bin
 RET_2_RTS=20:59:14 UTC Wed May 21 2014
 ConsecPostPassedCnt=69
 RET_2_RCALTS=
 DiagMonitorAction=Normal
 BOOT=
 ConfigReg=0x2102
rommon 2 >configreg

 monitor: command "configreg"  not found
rommon 3 >ConfigReg

 monitor: command "ConfigReg"  not found
rommon 4 >confreg

 Configuration Summary : 
 => load rom after netboot fails
 => console baud: 9600
 => autoboot from: commands specified in 'BOOT' environment variable

 do you wish to change the configuration? y/n  [n]:  y
 enable  "diagnostic mode"? y/n  [n]:  n
 enable  "use net in IP bcast address"? y/n  [n]:  n
 disable "load rom after netboot fails"? y/n  [n]:  n
 enable  "use all zero broadcast"? y/n  [n]:  n
 enable  "break/abort has effect"? y/n  [n]:  n
 enable  "ignore system config info"? y/n  [n]:  y

 change console baud rate? y/n  [n]:  n

 change the boot characteristics? y/n  [n]:  n

 Configuration Summary : 
 => load rom after netboot fails
 => ignore system config info
 => console baud: 9600
 => autoboot from: commands specified in 'BOOT' environment variable

 do you wish to save this configuration? y/n  [n]:  y
 You must reset or power cycle for new configuration to take effect

Again i am going rommon mode

[Leo Laohoo]

Syed, 

Post the entire bootup process.  We all want to see WHY the appliance keeps going into ROMmon.