02-25-2020 03:59 AM
HI!
I need some information regarding Cisco 6509-E Modules. Can someone tell me do the below mentioned module support NAT?
WS-X6548-GE-45AF
WS-X6148A-GE-45AF
02-25-2020 04:29 AM
On the 6500 it is the supervisor that supports NAT not the individual modules.
Jon
02-25-2020 05:10 AM
02-25-2020 05:37 AM
02-25-2020 05:36 AM
Hello @Hamidsattarrana ,
just to add to Jon's answer you configure NAT on SVI interfaces , this becomes an action in the TCAM table.
Being the Cat6500 a distributed platform the supervisor buid the master copy of TCAM table and then sends it to the line cards that have a CFC or DFC module.
in your case the linecard 6148 is likely able to connect only to 32 Gbps the shared bus
usually the linecards for sup720 should be something like 6xab with x=7 or x=8 these ones are the best as they can host the DFC and have a local copy of the TCAM table.
So I would put users on linecard 6148 and servers on linecard 6748
Hope to help
Giuseppe
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide