cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
7676
Views
11
Helpful
31
Replies

Cisco 886 Slow pppoe belgacom over isdn

Yordi Mahieu
Level 1
Level 1

            Hello,

for a costumer i have replaced there old small home router with this cisco 886.

i have configurd the atm interface, and the dialer interface.

i get a ip adres in the dialer from the isp , and i have internet connection.

everyting works except it is VERRY SLOW if i check the internet connection speed it is 0.49 Mbps down and 0.42 Mbps up (speedtest.net)

normaly i would get almost 4 Mbps download !

i have checkt with Belgacom (isp) the cabel and everyting is ok ! (with the previos router full speed internet! )

some portion of the config is included !

i tryed to put encapsulation on the atm aal5snap and aal5mux .... no diffrens...

interface ATM0

no ip address

no atm ilmi-keepalive

pvc 8/35

  pppoe-client dial-pool-number 1

      

interface Dialer1

mtu 1492

ip address negotiated

ip access-group naar-binnen in

ip nat outside

ip virtual-reassembly in

encapsulation ppp

dialer pool 1

ppp authentication chap callin

ppp chap hostname ######@SKYNET

ppp chap password 7 ############

31 Replies 31

Yordi Mahieu
Level 1
Level 1

Hello,

Strange but true,  i have chance the adsl controller mode from adsl 1 to auto, reboot the router and i have normal speed !!

very strange,  i think my ISP has update there DSLAM !

at first setup it was set at auto and did not had full speed !

thanks for everyone for helping me out !!

thank you !

You're wlecome, please remember to rate useful posts clicking on the stars below.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card