10-24-2012 05:17 AM - edited 03-04-2019 05:56 PM
Hello,
for a costumer i have replaced there old small home router with this cisco 886.
i have configurd the atm interface, and the dialer interface.
i get a ip adres in the dialer from the isp , and i have internet connection.
everyting works except it is VERRY SLOW if i check the internet connection speed it is 0.49 Mbps down and 0.42 Mbps up (speedtest.net)
normaly i would get almost 4 Mbps download !
i have checkt with Belgacom (isp) the cabel and everyting is ok ! (with the previos router full speed internet! )
some portion of the config is included !
i tryed to put encapsulation on the atm aal5snap and aal5mux .... no diffrens...
interface ATM0
no ip address
no atm ilmi-keepalive
pvc 8/35
pppoe-client dial-pool-number 1
interface Dialer1
mtu 1492
ip address negotiated
ip access-group naar-binnen in
ip nat outside
ip virtual-reassembly in
encapsulation ppp
dialer pool 1
ppp authentication chap callin
ppp chap hostname ######@SKYNET
ppp chap password 7 ############
01-16-2013 04:57 AM
Hello,
Strange but true, i have chance the adsl controller mode from adsl 1 to auto, reboot the router and i have normal speed !!
very strange, i think my ISP has update there DSLAM !
at first setup it was set at auto and did not had full speed !
thanks for everyone for helping me out !!
thank you !
01-31-2013 10:49 PM
You're wlecome, please remember to rate useful posts clicking on the stars below.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide