11-12-2012 02:50 AM - edited 03-04-2019 06:06 PM
Hi,
I have a couple of 887VA routers under my management. I noticed that none of them is allowing for bigger than 10 Mbit/s transfers via WAN link despite being synced with ie 15 Mbit/s or 17 Mbits/s.
I tried different IOS images and ADSL firmwares but it does not change anything.
#show controllers vdsl 0
Firmware Source File Name (version)
-------- ------ -------------------
VDSL user config flash:vdsl.bin-A2pv6C035j1 (10)
Modem FW Version: 120330_1738-4.02L.03.A2pv6C035j0.d23j
Modem PHY Version: A2pv6C035j0.d23j
Vender Version: Ap6v35j.23j 68
DS Channel1 DS Channel0 US Channel1 US Channel0
Speed (kbps): 0 15354 0 1021
As you can see modem syncs with 15 M. I should practically get that speed sometimes (off peak hours). I measure that by speedtest.net but also tried to download via ftp from ISP's server etc. Never exceeded 10 Mbits. I have a 3 more routers connected to same ISP (Eircom Ireland) and same problems.
Is there anything on 887VAs that would stop reaching maximum bandwidth ?
I attached example config - dont look at acls as it was mostly removed. Also couple of objects etc to not include ip addresses.
#show interfaces fastEthernet 0
FastEthernet0 is up, line protocol is up
Hardware is Fast Ethernet, address is 442b.03cd.7a9a (bia 442b.03cd.7a9a)
MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Full-duplex, 100Mb/s
11-12-2012 02:51 AM
Cisco IOS Software, C880 Software (C880DATA-UNIVERSALK9-M), Version 15.2(3)T1, RELEASE SOFTWARE (fc1)
11-12-2012 03:14 AM
Hi,
Ask your ISP about this issue. Check SLA agreement with them.
Regards.
11-12-2012 03:36 AM
When I connect stock router that comes from ISP works at full speed.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: