Ive just started up a new cisco 887va-w and the startup wizard doesnt start. Is there a way to make this manually start?
What i tend to do is run the wizard for the basic settings then run 10-15 lines from the client (depending on adsl or vdsl config) to configure the router.
But for some reason this one doesnt fire it after loging on with cisco cisco to 10.10.10.1 and changed the username and password. I just get the bebased cisco cp 'basic'. Cant see anyware on it to launch the wizard either.
Ive tried reset button on the back and reset to factory from cisco cp? any other ideas?
Software running on the unit is c800-universalk9-mz.spa.151-4,m4.bin
I have a pair of 3945 routers that are proving to be underpowered for the 100+ remote offices connecting to them. Fortunately I happen to have a couple of 4351 ISRs rated for significantly greater encrypted throughput. Is there any way I could upgrade the...
This article assumes you have the basic knowledge and experience with Cisco DNA Center and Identity Services Engine (ISE).Note when reading this doc the "Authentication Policy" referred to is part of Cisco DNA Center Onboarding section and ha...
Hi, The switch Cisco 2960CX-8PC-L supports PoE+, the total power budget is 124W, which means maximum 4 ports can support PoE+. Let's say the switch now has 2 PoE+ devices connected, does it mean the switch's PoE budget become 64W? Can we use th...
Membership in the Cisco Customer Connection program is required to attend. Registration is free and easy to complete. During registration, choose the Networking track. Once your membership is approved, you'll be able to register for this...