02-07-2018 10:45 PM - edited 03-05-2019 09:53 AM
Hi All,
Is there any command for snmp to send traps when temperature raise or fall from defined threshold on ASR100 series router? or Is this something happen by default by enabling 'snmp-server enable traps alarms' command?
Regards,
Godwin. S
Solved! Go to Solution.
02-09-2018 07:27 AM
hello,
you should have the following Mibs enabled in order to access hardware monitoring info via SNMP:
The old CISCO-ENVMON-MIB has been replaced by these Mibs for ASR1000 platform.
02-09-2018 07:27 AM
hello,
you should have the following Mibs enabled in order to access hardware monitoring info via SNMP:
The old CISCO-ENVMON-MIB has been replaced by these Mibs for ASR1000 platform.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: