cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1697
Views
5
Helpful
4
Replies

Cisco Firepower 1010 - Multicast Routing

Hi all,

hope to find everyone well.

I have a Cisco Firepower 1010 and I was asked if it could execute Multicast Routing, but after checking the manual it seems this isn't supported in this model. But the manual also states that Dynamic Routing is not supported and I can see BGP and OSPF in the configuration menu of the device. Please can anyone in fact confirm if multicast is not supported?

What other model of firepower can I use to execute multicast routing?

Thank you all before hand

 

1 Accepted Solution

Accepted Solutions

i normally do not use FDM, FMC it is possible.

Technically you can do using FDM too as below guide :

EDIT :

Multicast routing

FlexConfig

Configure multicast routing using FlexConfig objects from the Device > Advanced Configuration page.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post

4 Replies 4

balaji.bandi
Hall of Fame
Hall of Fame

what version FTD running, how are you managing this device ? using FMC or FDM ?

here is config guide and limitation :

https://www.cisco.com/c/en/us/td/docs/security/firepower/640/configuration/guide/fpmc-config-guide-v64/multicast_routing_for_firepower_threat_defense.html

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Hi @balaji.bandi 

 

thank you for the reply!

So, this device is being managed via the FDM and not the FMC and we are not thinking of putting it in the FMC. Only trough the FDM is Multicast feasible? 

Thank you

i normally do not use FDM, FMC it is possible.

Technically you can do using FDM too as below guide :

EDIT :

Multicast routing

FlexConfig

Configure multicast routing using FlexConfig objects from the Device > Advanced Configuration page.

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Thank you Balaji!

I was just checking the link that you posted and I can see multicast configuration for Precision Time Protocol (ISA 3000 only). But can't see anything else related with multicast 

Thank you

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco