cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
247
Views
2
Helpful
5
Replies

Cisco IOS XE - ip sla auto discovery

dyoma
Level 1
Level 1

Hi All

I have Cisco IOS XE Software, Version 16.09.08, ISR4431/K9.

When migrating a configuration from a Cisco 3945 (15.1(1r)T1) to a Cisco ISR4431/K9 (Cisco IOS XE Software, Version 16.09.08), I discovered that there was no "ip sla auto discovery" command. What is the alternative to this command for IOS XE?

 

 

1 Accepted Solution

Accepted Solutions

It defualt I think 

You can sure it there by using 

Show run all

See if it appear under correct tunnel interface 

MHM

View solution in original post

5 Replies 5

dyoma
Level 1
Level 1

All of the following commands migrated successfully except "ip sla auto discovery". How to add this command to Cisco IOS XE?

track 1 ip sla 1 reachability
!
track 2 ip sla 2 reachability


ip sla auto discovery
ip sla 1
icmp-echo 172.16.200.54 source-ip 172.16.200.53
ip sla schedule 1 life forever start-time now
ip sla 2
icmp-echo 172.16.150.1 source-ip 172.16.150.2
ip sla schedule 2 life forever start-time now
ip sla responder

if you specify source of ip sla echo why you need auto discovery ?

I think the config is correct and not need auto discovery 

MHM

dyoma
Level 1
Level 1

I really hope you’re right, I’ll test the router in productive mode, thank you!
Please tell me one more thing about DMVPN.

The “ip nhrp map multicast dynamic” command was entered without an error, but I can’t find it in the configuration itself by searching.

interface Tunnel102
  bandwidth 200000

 ip address 172.16.202.1 255.255.255.224

 ip access-group PERMIT_URAN in

 no ip redirects

 ip mtu 1427

 ip nhrp authentication dmvpn

 ip nhrp map multicast dynamic

 ip nhrp network-id 99

 ip nhrp holdtime 300

 ip tcp adjust-mss 1385

 ip policy route-map GuestWIFI

 ip ospf cost 60

 load-interval 30

 delay 1000

 tunnel source xxxxxxx

 tunnel mode gre multipoint

 tunnel key 100000

 tunnel protection ipsec profile DMVPN

It defualt I think 

You can sure it there by using 

Show run all

See if it appear under correct tunnel interface 

MHM

Yes, you are right, thank you!!!

Review Cisco Networking for a $25 gift card