In addition to my original question how can I tell what interface is connected to 188.8.131.52 in the following configuration?
ip route vrf customerA 184.108.40.206 255.255.255.240 220.127.116.11
The above configuration allows the static network 18.104.22.168 255.255.255.240 via ip address 22.214.171.124. The ip address will typically be the customers CE router. Is there a way of determining what interface on the PE is connected to the CE router with the ip address 126.96.36.199?
The distribution applies to protocols like OSPF, ISIS, BGP, etc.. and not MPLS. Redistribute connected basically redistribute the connected physical and/or logical interfaces for that specific router you are doing the redistribution. redistribute static redistribute static routes or default route to the routing protocol. If for example a CE has static routes configured towards a specific network and also peers with a provider via OSPF or BGP, these static routes need to be redistributed to OSPF or BGP to be reachable from remote networks.
Show CommandPurposeCiscoICX-RuckusShow Spanning tree infoShow spanning-treeshow 802-1wVerify Port-Channel / Link aggregation infosh lag briefsh etherchannel summaryShow CDC/LDP neighbor infoshow cdp neighbors detailsh lldp neighbors de sh mac a...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.
Introduction to SD-Access Multicast
The document describes the Cisco DNAC UI workflow introduced as part of the Cisco DNA Center1.3.3 release. The document covers the components of Multicast forwarding on SD-Access fabric and the configuration pushed to...