Hello;
I hope someone can provide me with extreme help on getting an internal network up and running; i had one internal network up and running before; but it seems like my second network were lagging and timing out then one day at work i had a power surge when i got home that cause a major shutdown all my equipment which i was unable to save configuration on my router and switch. So at this point im kinda stuck on what else i need to do. I was able to do a test on one of my computers; and at first my dhcp on my router was unable to provide my computer an ip address; so i had to change my computer to a static ip in order to connect to my router; once it was connected to my router i wasn't unable to connect to the internet; so after reviewing my configuration on the switch and router i was unable to pinpoint the problem if it was on the switch or on the router. Hopefully someone can provide some advice on what i need to do or change in order to get my internal network up and running. Listed below is my configuration of my router and switch please help !!!!!!!!!
Router config
ersion 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname R
!
boot-start-marker
boot-end-marker
!
no aaa new-model
!
resource policy
!
clock calendar-valid
!
ip cef
no ip dhcp use vrf connected
ip dhcp excluded-address 10.10.0.1 10.10.0.49
ip dhcp excluded-address 10.10.0.75 10.10.0.255
!
ip dhcp pool R_POOL
import all
network 10.10.0.0 255.255.255.0
update dns
default-router 10.10.0.1
dns-server 192.168.0.1
domain-name R.com
update arp
!
interface FastEthernet0
description OUT
ip address 192.168.0.80 255.255.255.0
ip access-group 100 out
ip nat outside
ip virtual-reassembly
speed auto
full-duplex
vlan-id dot1q 192
description OUT
pppoe enable
exit-vlan-config
!
interface FastEthernet1
ip address 10.10.0.1 255.255.255.0
ip access-group 100 in
ip nat inside
ip virtual-reassembly
speed 100
full-duplex
vlan-id dot1q 10
description IN
pppoe enable
exit-vlan-config
!
interface FastEthernet1.92
description OUT
encapsulation dot1Q 192
ip address dhcp client-id FastEthernet0
ip nat inside
ip virtual-reassembly
no snmp trap link-status
pppoe enable group global
!
interface Vlan192
no ip address
ip verify unicast source reachable-via any
ip mask-reply
ip accounting output-packets
ip nat outside
ip virtual-reassembly
!
interface Vlan10
no ip address
ip nat inside
ip virtual-reassembly
!
ip route 0.0.0.0 0.0.0.0 (Public IP)
!
ip nat pool pool1 192.168.0.80 192.168.0.255 netmask 0.0.0.0
ip nat inside source list 100 pool pool1
!
access-list 100 remark NAT Rule
access-list 100 permit tcp 0.0.0.0 255.255.255.0 eq domain any
access-list 100 permit tcp 0.0.0.0 255.255.255.0 eq www any
access-list 100 permit tcp 0.0.0.0 255.255.255.0 eq 443 any
access-list 100 permit tcp 0.0.0.0 255.255.255.0 eq 8080 any
access-list 100 permit ip 0.0.0.1 255.255.255.0 any
access-list 100 permit udp 0.0.0.1 255.255.255.0 any
access-list 100 permit tcp 0.0.0.1 255.255.255.0 any
Switch Config
hostname S1
!
boot-start-marker
boot-end-marker
!
no aaa new-model
system mtu routing 1998
no ip subnet-zero
!
spanning-tree mode pvst
spanning-tree extend system-id
!
vlan internal allocation policy ascending
!
interface FastEthernet0/12
description test 192
switchport access vlan 192
switchport trunk native vlan 192
switchport trunk allowed vlan 192
switchport trunk pruning vlan 192
switchport mode trunk
switchport nonegotiate
switchport port-security mac-address sticky
shutdown
speed 100
duplex full
spanning-tree portfast trunk
spanning-tree bpdufilter disable
spanning-tree bpduguard disable
!
interface FastEthernet0/12
description test 10
switchport access vlan 10
switchport trunk native vlan 10
switchport trunk allowed vlan 10
switchport trunk pruning vlan 10
switchport mode trunk
switchport nonegotiate
switchport port-security mac-address sticky
shutdown
speed 100
duplex full
spanning-tree portfast trunk
spanning-tree bpdufilter disable
spanning-tree bpduguard disable
!
interface GigabitEthernet0/1
description Out-to-WAN
switchport access vlan 192
switchport trunk native vlan 192
switchport trunk allowed vlan 192
switchport trunk pruning vlan 192
switchport mode trunk
switchport nonegotiate
switchport port-security mac-address sticky
speed 1000
duplex full
spanning-tree portfast
spanning-tree bpdufilter disable
spanning-tree bpduguard disable
!
interface GigabitEthernet0/2
description TRUNK-to-FE0/1
switchport access vlan 10
switchport trunk native vlan 10
switchport trunk allowed vlan 10
switchport trunk pruning vlan 10
switchport mode trunk
switchport nonegotiate
switchport port-security mac-address sticky
speed 100
duplex full
spanning-tree portfast
spanning-tree bpdufilter disable
spanning-tree bpduguard disable
!
interface Vlan10
description IN
ip address 10.10.0.2 255.255.255.0
ip mask-reply
ip information-reply
ip security dedicated unclassified genser
ip security add
ip security first
no ip route-cache
spanning-tree portfast trunk
!
interface Vlan192
description OUT
ip address dhcp client-id Vlan192
ip mask-reply
ip information-reply
ip accounting output-packets
ip security dedicated unclassified genser
ip security add
ip security first
no ip route-cache
ip tcp adjust-mss 1460
spanning-tree portfast trunk
