Showing results for 
Search instead for 
Did you mean: 

Cisco router 892 with two uplinks

Yura Kazakevich

Hello everyone. May be somebody can help me. I have router c892 (C890 Software (C890-UNIVERSALK9-M), Version 15.4(3)M4, RELEASE SOFTWARE (fc1)) with to uplinks: ISP1 (gi0) for Internet and ISP2 (fa8) to another network (

I tried to use PBR with match interface option, but no success (traffic from my Server to the host  has been nated to the ISP1 WAN IP).

My config in attach (real internet IPs were changed).

Please help.

3 Replies 3

Philip D'Ath
VIP Alumni
VIP Alumni

I don't really like that route notation for a normal Ethernet.  Try changing:

ip route FastEthernet8

to have a proper next hop of:

ip route

Is FastEthernet8 definitely up?

The other thought going through my mind is their is already a translation entry in the cache.  Try doing a:

clear ip nat ranslation *

Philip D'Ath
VIP Alumni
VIP Alumni

You could also try changing:

ip nat inside source list 102 pool to-bft overload


ip nat inside source list 102 interface FastEthernet8 overload

and see if that has any impact.  I'm not sure if using a pool with 1 single IP address equal to your interface IP is valid.

Yura Kazakevich

Hi guys! Thanks for your replies. I already found my mistake. It was ACL 102. I specified incorrect wildcard for subnet

When I fixed ACL 102 everything worked. Here is correct config:

access-list 102 permit ip
access-list 102 deny   ip any any

route-map SDM_RMAP_TO_BFT permit 10
 match ip address 102
 match interface FastEthernet8
route-map SDM_RMAP_1 permit 10
 match ip address 101
 match interface GigabitEthernet0

ip nat inside source route-map SDM_RMAP_1 interface GigabitEthernet0 overload
ip nat inside source route-map SDM_RMAP_TO_BFT interface FastEthernet8 overload

ip route

ip route permanent

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: