cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
285
Views
0
Helpful
1
Replies
Highlighted
Beginner

Cisco Router Hardware Redundancy

Hi All,

Is there any way to do Router Hardware Redundancy (HA) . My requirement is Active/passive whereby all my WAN link connected to WAN switch, distributed to two Routers. Once Primary router fails, standby router should pickup. All my WAN link is Ethernet base. The Problem is all WAN link comes with /30 IP only. How to achieve this? Is it possible to use HSRP?

Regards,

Nagis       

Regards, Nagis
1 REPLY 1
Contributor

Cisco Router Hardware Redundancy

Hi Nagiswaren,

You must be able to, Plese refer the link below

http://www.cisco.com/en/US/docs/ios/ipapp/configuration/guide/ipapp_hsrp_ps6350_TSD_Products_Configuration_Guide_Chapter.html

Please rate helpful posts

Regards
Thanveer
"Everybody is genius. But if you judge a fish by its ability to climb a tree, it will live its whole life believing that it is a stupid."

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards