we have Cisco 3825 and we need to add E1 card
VWIC-2MFT-E1-DIR (is it support for 3825 )
WIC Slot 3:
E1 Drop&Insert (2 port) WAN daughter card with relays
WIC module not supported/disabled in this slot
CNR-Side-A(config)#network-clock-participate wic 3
WIC slot is empty or does not support clock participate
You must make a username using the CLI before it will let you use the SDM and they have to have level 15 access. Also with the new version I noticed that it demands that you change any user named cisco before it will proceed into the main router config.
username myuser privilege 15 password mypassword
I can't say I'm a fan of the SDM at this point. Too many automated tasks for my liking. Looks like I'll be sticking with the CLI for a while.