06-14-2019 12:46 AM
Dear All,
Can you Please help me with some advice regarding the following issue?
We have a CISCO3945E/K9 for which password recovery functionality was disabled.
I have tried to factory reset the router but i'm not able to break into ROM.
I have tried everything possible, even to remove the flash card but i'm not able to break into ROM...
Do you have any idea how cold I reset the router to factory default?
System Bootstrap, Version 15.1(1r)T5, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 2012 by cisco Systems, Inc.
Total memory size = 1024 MB - DIMM0 = 512 MB, DIMM1 = 512 MB
CISCO3945-CHASSIS with C3900-SPE250/K9 with 1048576 Kbytes of main memory
Main memory is configured to 72/72(dimm 0/1) bit mode with ECC enabled
Readonly ROMMON initialized
PASSWORD RECOVERY FUNCTIONALITY IS DISABLED
Booting c3900e-universalk9-mz.SPA.155-3.M6.bin ...
Any advice will be much appreciated!
Many thanks in advance!
Kind regards,
Costinel S.
06-14-2019 01:00 AM
Hello,
when the image is decompressing:
Self decompressing the following image:
################################################[OK]
Are you trying the break sequence within 5 seconds of seeing this line ?
06-14-2019 01:16 AM
Hi Georg,
While trying to break sequence when mentioned prompt appeared nothing is happening.. booting process is not interrupted, it continues until it's finished.
Thanks !
Kind regards,
Costinel S.
06-14-2019 01:42 AM
Hello,
check if your flash actually contains a valid IOS image (dir flash:)...
06-14-2019 01:01 AM
May be client sending "Ctrl+Break" that is not recognized by the device.
06-14-2019 01:04 AM
06-14-2019 02:29 AM
Go HERE.
06-19-2019 02:05 AM
Hi,
Thanks !
But it does't work...
The sequence after that site recommend to issue the brake command does not appear on CISCO3945E/K9 booting process.
Kind regards,
Costinel S.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: