CMTS-cable modem termination system

[CSCO10320953]

Hi All,

Is CMTS7225(UBR7200-NPE-G1) require any license for activating CMTS feature and line cards(U7225VXR-M28EUG1)?

Because I am not able to configure ip address for cable interface .

CMTS(config-if)#ip ?
Interface IP configuration subcommands:
  dhcp                Configure DHCP parameters for this interface
  header-compression  IPHC options
  rsvp                RSVP Interface Commands
  rtp                 RTP parameters
  subscriber          IP session configuration options
  vrf                 VPN Routing/Forwarding parameters on the interface

Regarding,

Kumaran M

[mavespig]

Hi Kumaran,

Did you try to associate the cable interface to a bundle, and configure the IP in the bundle?

For example:

int cable1/0

  cable bundle 1

int bundle 1

  ip address x.x.x.x

To verify your license details, you may use the command "show license detail"

Hope this helps

Marco

[CSCO10320953]

Marconi,

>>>>>Did you try to associate the cable interface to a bundle, and configure the IP in the bundle?

When  we do two or more physical interface configration  ,bundle is required.

But i am using single cable inteface ,Still i have to use bundle concept.

Pl confirm,if yes,

I can able to configure ip addres in bundle interfce 

interface Bundle1

ip address x.x.x.x x.x.x.x

cable arp filter request-send 3 2

cable arp filter reply-accept 3 2

cable helper-address x.x.x.x  

>>>>>>To verify your license details, you may use the command "show license detail"

1.Pl confirm whether license is required for CMTS

2.show license detail ,Command is not working.

WT-CMTS-BLR#sh l ?

l2tp       l2tun     line     llc2   lnm

local-ack  location  logging  login

FYI.

>>>>>

[CSCO10320953]

Marco,

I am waiting for your valuable input on my query.

Thanks,

[mavespig · Accepted solution]

Kumaran,

This is an open community based on best-effort help.

If you need a reply in a timely manner, please open a TAC case.

As far as I know, only the new 20x20 and 8x8 cards need a specific license, you are using a 28.

A bundle interface can be used even for a single cable interface. You should use the bundle for any L3 features, and configure L2 features under the cable interface.

Regards