Hey there Guys & Gals,
I decided to try the compound frame-relay switch configuration using two 2610's. I need to extend the FR clouds to accomendate nine routers. The reference is here: http://www.internetworkexpert.com/resource...frame-relay.htm
For some reason I cannot get it to work for the frame relay traffic ........... I can ping the tunnel0 destinations, so reachability is there for NON-Frame-relay traffic. But I cannot get the FR traffic to pass over the tunnel. I ran some debugs from R1 and its stating that the encapsulation is failing. I also set this up using a serial1/0 {Tunnel source Serial1/0} interface on each FR switch to no avail. Encapsulation is failing.
{R1 - FR1 - FR2 - R7}
Any suggestions???? ..... THANKS!!!!
Configurations:
Frame relay switch #1
********************
interface Serial1/0
description Connected to R3
no ip address
encapsulation frame-relay
clock rate 128000
no fair-queue
frame-relay intf-type dce
frame-relay route 311 interface Serial1/1 113
frame-relay route 312 interface Serial1/2 213
frame-relay route 314 interface Serial1/4 413
frame-relay route 315 interface Serial1/5 513
frame-relay route 317 interface tunnel0 713
frame-relay route 318 interface tunnel0 813
frame-relay route 319 interface tunnel0 913
no shut
!
interface Serial1/1
description Connected to R1
no ip address
encapsulation frame-relay
clock rate 128000
frame-relay intf-type dce
frame-relay route 102 interface Serial1/2 201
frame-relay route 103 interface Serial1/3 301
frame-relay route 104 interface Serial1/4 401
frame-relay route 105 interface Serial1/5 501
frame-relay route 106 interface Serial1/6 601
frame-relay route 113 interface Serial1/0 311
frame-relay route 107 interface tunnel0 701
frame-relay route 108 interface tunnel0 801
frame-relay route 109 interface tunnel0 901
no shut
!
interface Serial1/2
description Connected to R2
no ip address
encapsulation frame-relay
clock rate 128000
frame-relay intf-type dce
frame-relay route 201 interface Serial1/1 102
frame-relay route 203 interface Serial1/3 302
frame-relay route 204 interface Serial1/4 402
frame-relay route 205 interface Serial1/5 502
frame-relay route 206 interface Serial1/6 602
frame-relay route 213 interface Serial1/0 312
frame-relay route 207 interface tunnel0 702
frame-relay route 208 interface tunnel0 802
frame-relay route 209 interface tunnel0 902
no shut
!
<SNIP>
!
!
interface Async65
encap ppp
ip address 177.7.7.1 255.255.255.252
async dynamic routing
async mode dedicated
!
interface Tunnel0
tunnel source Async65
tunnel destination 177.7.7.2
!
<SNIP>
line aux 0
modem InOut
transport input all
rxspeed 128000
txspeed 128000
flowcontrol hardware
line vty 0 4
no login
!
!
end
Frame relay switch #2
********************
interface Serial1/1
description Connected to R7
no ip address
encapsulation frame-relay
clock rate 128000
no arp frame-relay
no frame-relay inverse-arp
frame-relay intf-type dce
frame-relay route 708 interface Serial1/2 807
frame-relay route 709 interface Serial1/3 907
frame-relay route 701 interface tunnel0 107
frame-relay route 702 interface tunnel0 207
frame-relay route 703 interface tunnel0 307
frame-relay route 704 interface tunnel0 407
frame-relay route 705 interface tunnel0 507
frame-relay route 706 interface tunnel0 607
frame-relay route 713 interface tunnel0 317
no shut
!
!
<SNIP>
!
interface Async65
encap ppp
ip address 177.7.7.2 255.255.255.252
async dynamic routing
async mode dedicated
!
interface Tunnel0
tunnel source Async65
tunnel destination 177.7.7.1
!
!
<SNIP>
line aux 0
modem InOut
transport input all
rxspeed 128000
tspeed 128000
flowcontrol hardware
line vty 0 4
no login
!
!
end
