05-14-2013 07:35 PM - edited 03-04-2019 07:53 PM
Hi forum,
I get stuck in one case. One of my customer has two FTTH lines. I have to config PPPoE in routers. In one line I config succesfully, but one line never up.
I call to ISP they ask me to config extactly VLAN id 10 in the physical subinterface. But in subinterface there is no command "pppoe-client dial-pool-number". I check the old modem FTTH, they also config VLAN 10 in Wan interface. I tell ISP why we have the same two FTTHs, but two differrent config ways. ISP says because the two line run in two different infrastructure, two different devices. I don't know how to do now? Can anyone tell me what going on here? The problem stay in customer side or ISP side.
Here is my PPPoE config:
interface FastEthernet0/0
no ip address
duplex auto
speed auto
pppoe enable
pppoe-client dial-pool-number 10
!
interface FastEthernet0/1
ip address 192.168.1.1 255.255.255.0
ip nat inside
ip virtual-reassembly
duplex auto
speed auto
!
interface Serial0/0/0
no ip address
shutdown
clock rate 2000000
!
interface Serial0/0/1
no ip address
shutdown
clock rate 2000000
!
interface ATM0/1/0
no ip address
shutdown
no atm ilmi-keepalive
dsl operating-mode auto
!
interface Dialer1
ip address negotiated
ip nat outside
ip virtual-reassembly
encapsulation ppp
dialer pool 10
ppp authentication pap chap callin
ppp chap hostname xxxxx
ppp chap password 0 xxxxx
ppp pap sent-username xxxxx password 0 xxxx
ppp ipcp dns accept
ppp ipcp route default
ppp ipcp address accept
!
Thank to any replies
05-15-2013 07:22 PM
Thanks you, Paolo Bevilacqua,
I has upgraded IOS and see the command pppoe-client in sub-interface.
I cannot vote you now, because the history post disappeared???
05-16-2013 02:03 AM
I have deletet my postings due to the unfair rating received.
05-16-2013 02:26 AM
I don't understand.
At that time I just rate the post you reply right after my second post. I wait to test upgrading IOS then will say thanks to you and mark the question as answered.
Anyway sorry to not make you happy.
Actually I should believe in you at the first reply.
05-16-2013 02:44 AM
If you are not ready to leave full rating for postings that are 100% correct and made with the will to help, please do not leave any rating at all.
10-30-2018 01:39 AM
Hi,
check to bridge mode configuration on the device.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: