cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
308
Views
0
Helpful
0
Replies
Highlighted
Beginner

Configuration WAAS (WCCP and AppNav)

Hello.

I have a network with 2 MPLS providers, where both arrive at my main site and my remote sites. In my network I have implemented WAAS with WCCP intercept mode. I have this mode of interception in all my remote sites for the optimization of my traffic. Recently a new remote site was added and we asked our MPLS providers to configure WAAS on their routers that deliver the MPLS link. These were configured with an AppNav interception mode. These new routers in the new site were already added to the WAAS Central Manager, however although they are already seen online in the WAAS Central Manager, it is not observed that they are optimizing traffic in any of the routers configured as AppNav. I have searched in Cisco documentation but I have not found if the interpetion method should be the same, will this be affected by the fact that these routers are not optimizing my traffic? Will some configuration be missing so that traffic can be optimized?

 

 

Thank you very much.

Regards!

Everyone's tags (3)
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards