Cisco Community
English
Register
Congratulate December's Spotlight Awardees. CLICK HERE
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
368
Views
0
Helpful
0
Replies
Highlighted
autumn2012
Beginner
Beginner
‎12-03-2012 04:51 PM
‎12-03-2012 04:51 PM

Configure ME-3400 for AT&T 50M Metro E

Hello,

We are trying to configure a Cisco ME-3400 Switch (with IP Routing IOS) to connect to an AT&T 50Mbps Metro Ethernet Circuit.  Below is some IP address data to assist.

Assigned Class C Block:

12.150.225.0/24


WAN IP Address:

12.240.24.90

We just need Internet Connection. We are using a Juniper NS-500 behind the switch for rate (bandwidth) limiting and QoS.  The hand-off from AT&T is a 100M Ethernet. So, we can use FA0/1 for the AT&T side and Gi0/1 for the connection to the Juniper NS-500.  All other ports will be unused.

Thanks for your help,

Shawn

Labels:
0 Helpful
Reply
0 REPLIES 0
Latest Contents
Cisco DNA Center Resources
Created by traviwil on 01-15-2021 03:59 PM
4
43
4
43
Cisco DNA Center Get Started Automation Assurance Platform AI/ML Deployment Support   Get Started What's new in Cisco DNA Center 2.1.2 Cisco DNA Center 2.1.2.x Features and Capabilities Cisco DNA Center -Intent Based Networki... view more
xFSU on Catalyst 9300: The Always-On Access Network
Created by arubhat on 01-15-2021 03:08 AM
0
0
0
0
A major international airport is looking to build a cutting-edge new terminal, designed to run 24/7 with no interruptions. With the airport always on round the clock, a critical component required to support this is the surveillance infrastructure, which ... view more
Automated workaround for CSCvw63161
Created by Jeffrey Keown on 01-14-2021 03:16 PM
0
5
0
5
 
Host 0000.0000.0101 in vlan 1 is flapping between port Gi1/0...
Created by Alfredo Pippo on 01-14-2021 07:32 AM
2
0
2
0
Dear expert,I am facing an issue which you may come across before. Grateful if you would teach me how to do it.I have a Cisco WS-C3650-24TS switch in MZ which I would like to configure so that on the GigabitEthernet1 / 0/1 portis configured with VLAN 100,... view more
Top of rack switch selection - RJ45, Cat9k or Nexus
Created by carl_townshend on 01-14-2021 01:21 AM
2
0
2
0
Hi AllWe are looking at some new switches for our top of racks in our DC.We have looked at the 9300 series UX models with the big buffers which is classed as a high scale model.I have tried to look at some Nexus models for top of rack, but there appears t... view more
Content for Community-Ad