08-08-2013 02:41 AM - edited 03-04-2019 08:42 PM
Where do I find complete information on how to configure a WAN with a 2504 controller and Aironet 2602E Access Points.
Thanks in advance
08-08-2013 01:25 PM
I will tel u in short.
Terminate one of interface form WLC to your switch. Your Switche x/x Interface should be in Trunk and Native vlan Allowed.
When u will start WLC
it will ask u to configure management interface give ip to it
Servcie Management Interface give ip to it Must be of same subnet as of management.
Cofigure virutal interface as 1.1.1.1 IP.
after that u will be able to access WLC over Web.
Access it
Crate SSID and define authentication mechanism.
Lastly
Connected Access Point to Switch
Connect Console to AP give it ip address
lwapp ap ip address x.x.x.x
lwapp ap getway x.x.x.x
lwapp controller ip address x.x.x.x
After that app will fine controller and it will appear in wlc
i have given u example if u do some research everthing is availabe on Cisco Site u it will be better.
*** Do rate Helpful Posts ***
Jawad
08-08-2013 05:25 PM
08-20-2013 02:40 AM
On the 2602i AP.
Configuring it for the 1st time (out from the box). I can access the CLI via console but I don't know the commands to enable accessing the AP via http because all the configuration guides im seeing here use the web configs.
Please assist.
08-20-2013 08:10 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide