cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1671
Views
0
Helpful
1
Replies

Configuring DSL-GROUPS on HWIC-4SHDSL-E

kathy.vizena
Level 1
Level 1

I am trying to configure multiple dsl-groups on a HWIC-4SDHSL-E module and the option does not exist.  According to the Cisco documentation I should be able to do this, but I only get pairs as an option.

1921(config-controller)#dsl-group ?
  pairs  Link number
  <cr>

http://www.cisco.com/en/US/docs/routers/access/interfaces/software/feature/guide/GSHDSL_EFM_HWICS.pdf

This is what I am trying to do which I have done before on the 1841.

dsl-group 0 pairs  0, 1

  shdsl annex A-B

  shdsl rate 4096

!

dsl-group 1 pairs  2, 3

  shdsl annex A-B

  shdsl rate

Is it because this is only a EFM HWIC and not an EA HWIC?   Then the documentation is wrong.

Any help would be appreciated.

1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

The documentation can be wrong, however the data sheet does not mention multiple groups support:

http://www.cisco.com/en/US/prod/collateral/modules/ps5949/data_sheet_c78-599774.html

Review Cisco Networking for a $25 gift card