08-08-2011 07:15 AM - edited 03-04-2019 01:12 PM
Hi,
I'm going to be swapping out a WIC-1DSU-T1-V2 for a new VWIC2-2MFT-T1/E1, going from one to two T-1s.
This is on a 2800 router running 12.4(23)
Can anyone share...
configuration examples for the two T-1 setup ?
commands to verify the installation (show me the two T-1s are successfully bonded and communicating as one logical entity) ?
any other tips ?
Thanks.
Solved! Go to Solution.
08-08-2011 07:18 AM
Hopefully this will help.
08-08-2011 07:18 AM
Hopefully this will help.
08-08-2011 07:25 AM
Thanks much. I must have waited 30 seconds for a reply
08-11-2011 08:38 AM
In the example, what are the zeros for on the end of each serial interface?
Would that be channel-group 0?
Serial0/2/0:0 unassigned YES manual down down
Serial0/2/1:0 unassigned YES manual down down
Serial0/3/0:0 unassigned YES manual down down
Serial0/3/1:0 unassigned YES manual down down
08-29-2011 12:58 PM
Provider had brought up one T-1 weeks ago and finally says they have the second T-1 up now but fails to loop to 2801.
Since half of the bundle has been up, what commands would you recommend I use to prove the bundle and/or interfaces are correctly configured?
The are claiming CPE issue.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: