08-08-2011 07:15 AM - edited 03-04-2019 01:12 PM
Hi,
I'm going to be swapping out a WIC-1DSU-T1-V2 for a new VWIC2-2MFT-T1/E1, going from one to two T-1s.
This is on a 2800 router running 12.4(23)
Can anyone share...
configuration examples for the two T-1 setup ?
commands to verify the installation (show me the two T-1s are successfully bonded and communicating as one logical entity) ?
any other tips ?
Thanks.
Solved! Go to Solution.
08-08-2011 07:18 AM
Hopefully this will help.
08-08-2011 07:18 AM
Hopefully this will help.
08-08-2011 07:25 AM
Thanks much. I must have waited 30 seconds for a reply
08-11-2011 08:38 AM
In the example, what are the zeros for on the end of each serial interface?
Would that be channel-group 0?
Serial0/2/0:0 unassigned YES manual down down
Serial0/2/1:0 unassigned YES manual down down
Serial0/3/0:0 unassigned YES manual down down
Serial0/3/1:0 unassigned YES manual down down
08-29-2011 12:58 PM
Provider had brought up one T-1 weeks ago and finally says they have the second T-1 up now but fails to loop to 2801.
Since half of the bundle has been up, what commands would you recommend I use to prove the bundle and/or interfaces are correctly configured?
The are claiming CPE issue.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide