Hi.
I'm trying to setup Cisco 897-K9 for my VDSL internet connection with dynamic IP (if I will successful then I’ll order a /29 IP prefix).
I was checking different configurations but no of them work.
Some people say I need to put for interface ATM0:
interface ATM0
no ip address
no atm ilmi-keepalive
pvc 8/35
encapsulation aal5mux ppp dialer
pppoe-client dial-pool-number 1
Others that interface ATM0 should be with no config and shutdown.
Also same with subinterfaces:
1).
interface ATM0.3 point-to-point
description Netia
pvc 8/35
encapsulation aal5snap
pppoe-client dial-pool-number 3
2).
interface Ethernet0.101
encapsulation dot1Q 101
pppoe-client dial-pool-number 1
With route or wiuthout route (ip route 0.0.0.0 0.0.0.0 Dialer1)
I’m really confused. Anyone can tell me how to configure it properly to make it work? Maybe it's the fault of my Controller firmware or something else
Info from my ISP (NETIA) about my line:
VDSL line
VPI: 8
VCI: 35
Multiplexing: LLC
Encapsulation: PPPoE
(Cable with rj11)
Modem firmware: VA_A_39m_B_38h3_24h.bin
Router#show controller vdsl 0
Controller VDSL 0 is UP
Daemon Status: Up
XTU-R (DS) XTU-C (US)
Chip Vendor ID: 'BDCM' 'IFTN'
Chip Vendor Specific: 0x0000 0xB203
Chip Vendor Country: 0xB500 0xB500
Modem Vendor ID: 'CSCO' ' '
Modem Vendor Specific: 0x4602 0x0000
Modem Vendor Country: 0xB500 0x0000
Serial Number Near: FCZ201790ZL C897VA-K 15.7(3)M4a
Serial Number Far: 5502610891
Modem Version Near: 15.7(3)M4a
Modem Version Far: 0xb203
Modem Status: TC Sync (Showtime!)
DSL Config Mode: VDSL2
Trained Mode: G.993.2 (VDSL2) Profile 17a
TC Mode: PTM
Selftest Result: 0x00
DELT configuration: disabled
DELT state: not running
Full inits: 1
Failed full inits: 0
Short inits: 0
Failed short inits: 0
Firmware Source File Name
-------- ------ ----------
VDSL embedded VDSL_LINUX_DEV_01212008
Modem FW Version: 4.14L.04A
Modem PHY Version: A2pv6C039t.d24o_rc1
Trellis: ON ON
SRA: disabled disabled
SRA count: 0 0
Bit swap: enabled enabled
Bit swap count: 1 0
Line Attenuation: 23.9 dB 0.0 dB
Signal Attenuation: 0.0 dB 0.0 dB
Noise Margin: 9.2 dB 9.0 dB
Attainable Rate: 33566 kbits/s 5940 kbits/s
Actual Power: 13.2 dBm 7.6 dBm
Per Band Status: D1 D2 D3 U0 U1 U2 U3
Line Attenuation(dB): 18.4 45.8 71.1 8.5 36.9 56.5 N/A
Signal Attenuation(dB): 18.3 45.3 N/A 8.5 36.7 55.5 N/A
Noise Margin(dB): 9.2 9.3 N/A 9.4 9.0 9.0 N/A
Total FECC: 0 0
Total ES: 0 0
Total SES: 0 0
Total LOSS: 0 0
Total UAS: 38 38
Total LPRS: 0 0
Total LOFS: 0 0
Total LOLS: 0 0
DS Channel1 DS Channel0 US Channel1 US Channel0
Speed (kbps): 0 30547 0 5492
SRA Previous Speed: 0 0 0 0
Previous Speed: 0 0 0 0
Reed-Solomon EC: 0 0 0 0
CRC Errors: 0 0 0 0
Header Errors: 0 0 0 0
Interleave (ms): 0.00 8.00 0.00 8.00
Actual INP: 0.00 2.00 0.00 1.10
Training Log : Stopped
Training Log Filename : flash:vdsllog.bin
——————
