cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
421
Views
0
Helpful
1
Replies

Correct way to configure Rendezvous point redundancy when using Auto-RP

carl_townshend
Spotlight
Spotlight

Hi there

Can anyone tell me when we use Auto RP, do you need to configure Anycast RP and use the same loopback IP on 2 different routers with MSDP between them? or can you use different IP addresses and just let the mapping agents pick the best one and if one fails they will advertise the other one?

How should it be done when using Auto RP, what would the config look like?

cheers

1 Reply 1

marce1000
VIP
VIP

 

 - Check the document below which also discusses a few anycast scenarios and or options :

              https://www.cisco.com/c/en/us/td/docs/ios/solutions_docs/ip_multicast/White_papers/rps.html

 M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: