Country IP address for hub and spoke model

[jeffkim.cisco]

I have 23 locations in EU.

It is a hub and spoke model.

All the spoke traffic to outside will transverse to UK and goes out from UK.

Is there ANY method to contain the user's original location?

Let's say user from France will go out to the internet through Hub (U.K), and public websites will recognize the user from U.K not France.

How can I tell websites that this traffic is coming from France not U.K?

Thank you,

[Georg Pauwen]

Hello,

which devices are being used ? On Cisco devices, you can enable syslogging for NAT translations (ip nat log translations syslog). Assuming that each country has a different subnet, that would enable you to log the source and the destination of the NAT entries...

That of course is a very rudimentary answer. We would need to know the details of your network setup....