09-27-2012 12:02 AM - edited 03-04-2019 05:41 PM
Hi Experts,
I'm a bit confused on why, when I issue a "show route" command on my Cisco 5510 ASA the default route shows: d*
Please see below for the output.
There seem to be no small letter "d" in the codes below.
Why am I getting this kind of default route?
Result of the command: "sh route"
Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area
* - candidate default, U - per-user static route, o - ODR
P - periodic downloaded static route
Gateway of last resort is x.x.x. to network 0.0.0.0
C a.a.a.a 255.255.255.0 is directly connected, inside
C y.y.y.y 255.255.255.248 is directly connected, outside
d* 0.0.0.0 0.0.0.0 [1/0] via x.x.x.x, outside
Solved! Go to Solution.
09-27-2012 06:17 AM
Is it not the default route being received via DHCP on your WAN interface?
09-27-2012 06:26 AM
Hi,
I think this is a default route learned via DHCP with ip address dhcp setroute command.
Regards.
Alain
Don't forget to rate helpful posts.
09-27-2012 06:17 AM
Is it not the default route being received via DHCP on your WAN interface?
09-27-2012 06:26 AM
Hi,
I think this is a default route learned via DHCP with ip address dhcp setroute command.
Regards.
Alain
Don't forget to rate helpful posts.
09-27-2012 03:10 PM
Alain, Pompey,
Thank you for the reply. That clears my confusion.
May I know if this d* route is given priority over S*?
Regards,
Jemel
09-27-2012 07:00 PM
Hello,
i think S* has priority .
thanks
09-27-2012 10:53 PM
Hi,
I don't think so as these are both static routes with an AD of 1.
Regards.
Alain
Don't forget to rate helpful posts.
09-29-2012 01:06 AM
Hi Alain,
I also thought it would be the same because both have an AD of 1.
If so, what would be the best practice, if I have 2 routes going to the internet?
Interface1 - is learned via DHCP from ISP, the other interface2 - PPPoE from ISP?
Should I enable set-route on both interfaces?
Or should I only enable it on the active interface that's is forwarding the traffic?
Thank you.
Regards,
Jemel
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide