cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Cisco Community Designated VIP Class of 2020

456
Views
0
Helpful
1
Replies
Highlighted
Enthusiast

default route into NSSA totally stubby

I read that an NSSA totally stubby area receives a default route from the its ABR. In my lab config, I still do not get the default route on R4.

any idea?

Everyone's tags (2)
1 REPLY 1
Enthusiast

Re: default route into NSSA totally stubby

I found it.

R3 and R4 were not already OSPF Neighbors. They are connected through Frame relay. R3 interface is "point-to-point" OSPF network type. R4 however, has interface ser0/0 in "NBMA" OSPF Network type.

I corrected the network type under ser0/0 of R4 and it works

CreatePlease to create content
Content for Community-Ad
FusionCharts will render here