cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
548
Views
5
Helpful
1
Replies

Destination NAT via NVI

dario.didio
Enthusiast
Enthusiast

Hi,

I'm trying to configure destination NAT via the NVI on a Cisco router.

I have the command 'ip nat source static...' which works fine for source nat; but I don't kow how to do the destination nat, there is no command ip nat destination...

any help is appreciated!

thanks

1 Reply 1

Hello Dario,

You can achive destination NAT using route-map, have a look on the below example.

access-list 201 permit ip host 10.10.14.1 host 192.168.14.130
access-list 202 permit ip host 10.10.14.1 host 192.168.15.122

route-map NAT1
match address 201

route-map NAT2
match address 202

ip nat inside source static 10.10.14.1 192.168.130.55 route-map NAT1
ip nat inside source static 10.10.14.1 192.168.150.55 route-map NAT2

Note :- "ip nat inside" and "ip nat outside" are configured on respective interfaces

Hope it Helps..

-GI

Rate if it Helps..

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers