02-14-2020 03:21 AM
I have a question here regarding DHCP
R1 and R2 connected to a switch with vlan 10 and vlan 20 respectively and the switch is connected to a Router R3 in which i have configured DHCP with ip pool configured.
Now my question is how these two routers are going to get separate IP pool segments like R1 10.0.0.0 and R2 20.0.0.0
02-14-2020 04:43 AM
1. Setup required IP Pools on DHCP router (R3),
2. Configure your VLAN interface / SVIs with "ip helper-address x.x.x.x" (x.x.x.x is the IP of your DHCP router); SVI can be setup on your switch if it's a L3 switch or you can create Sub Interfaces on R3, if you are setting up SVIs on R3 then make sure switch and R3 connected over trunk port.
3. Assign respective VLANs on switch ports connected to router R1 & R2 interfaces.
02-14-2020 06:23 AM
Not sure if I understod the question fully, however if you want R1 and R2 to obtain a DHCP address, you could configure it like this.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide