In our environment we have edge 3845 Router with UTP Leased Line working fine with 8 dialup connection and 23 remote location branches
, in this Router we have 8 dial up connections and 23 Remote location branches are connected, now management got another Fiber Lease Line and management wants to deployed in The New Fiber/ UTP Lease Line in New Router which is 3945 ,
My question is is there any possible way to configure the Dial up Connection in old 3845 Router and 23 branches in new router if yes how to give connectivity between these two old 3845 and new 3945 Routers ,
and i have to configure the UTP and Fiber Leas line in New Router both shoud work same if one link fail another will act as primary , both are working with BGP ,
Digital innovation is overwhelming the branch and WAN. More specifically, 80 percent of employees and customers work in or are served in branch offices*, which is leading to a 73 percent growth in mobile devices from 2014 to 2018**. The...
Purpose of the document
This document describes the general recommendations or best practices when designing and deploying the Cisco SD-Access technology. The document assumes that the reader has a general overview of Cisco's SD-Access ...
Dear All, When I use the show interface command on the Cisco Router ISR-4331, it will display as below information. The word that I mark red, it refresh every 5 seconds. But, I compare with the old router model like a Cisco 29XX or 28X...