cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
533
Views
0
Helpful
2
Replies
Highlighted
Beginner

DMVPN Load Balancing

Hi all

We got two DMVPN hubs primary and secondary(Fail-over) 

we use 4G EHWICS to get connection.

I want to use two 4G EHWICS (Same or different ISP's) to do load balance.

I am thinking to generate two tunnels 0 & 1 going from Cel 0/0/0 and 0/1/0 respectively.

It is not helping me, I want to make sure I am on right track that this thing is possible or not. (CISCO 1921)

If possible is there any article from which I get support for configuration how to achieve load balancing on 2 Tunnels using different WAN connections. 

2 REPLIES 2
Highlighted
Beginner

are the routes from these 2 tunnels in ECMP ? 

if so  ,, try 

ip cef load-sharing algorithm tunnel

 

int tunnel X

     ip load-sharing  (   per-destination /  per-packet )

 

hope it helps

Highlighted
Beginner

Hi,

 

Use F5-1600 for load balancing. This is the best solution for multiple ISPs.

 

 

Jerry Paul

www.thenetworkhardware.com