Hi,
I have a scenario were i have to implement a solution which allows for dual ISP redundancy on spoke into dual hubs in a dmvpn environment.
I have created two tunnel interfaces, both have tunnel source set at each respective physical interface, the problem is that i can only have one tunnel active at any time, the other will never get past ike phase one and vice versa.
If i source both tunnels from one of the physical interfaces, both tunnels comes up, no problem.
I have tried using different vrf´s for each tunnel and corresponding phy. Interface.
Any known limitations using 2 physical interfaces in an active/active role at the spoke site?
Both hub and spoke running same Denali 16.3.7 release.
Kind regards,
Eirik