Hello Heinz,
No, it makes no difference in the configuration whether it is with or without a splitter. The card fits for Annex B.
You can still force a DSL syncro. method (adsl1, adsl2+, vdsl) with the "dsl operating-mode" command. But you don't actually need it since it is default set to automatic. If the EHWIC card get its synchronization with the wall socket it must also do it on the splitter.
Can you send the debug messages from console during sync?
Also if you synced the card directly with telephone wall socket the outputs of the following commands.
(show controllers vdsl x/x/x or show controllers atm x/x/x)
Check if the 1to1 cable is really connecting, especially in the female connector of Splitter.
!
controller VDSL 0
modem disableV43
!
interface Ethernet0
no ip address
shutdown
!
interface ATM0
description DSL
no ip address
load-interval 30
no atm auto-configuration
no atm ilmi-keepalive
no atm address-registration
no atm ilmi-enable
!
interface ATM0.1 point-to-point
snmp trap link-status
pvc 1/32
pppoe-client dial-pool-number 1
!
!
interface Dialer1
ip address negotiated
no ip proxy-arp
ip mtu 1492
ip virtual-reassembly in
encapsulation ppp
no ip route-cache cef
no ip split-horizon
ip tcp adjust-mss 1452
load-interval 30
dialer pool 10
ppp authentication chap callin
ppp chap hostname xxxxxxxxxxxxxxxxxxxxxxx
ppp chap password 7 xxxxxxxxxxxxxxxxxxxxx
ppp ipcp dns request
ppp ipcp mask request
(ppp ipcp route default). <-- Dafür kann die statische Route entfallen !
Greetings,
Patrick
