cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
899
Views
0
Helpful
3
Replies

EIGRP Neighbor flapping 4500 & 6500

Borman Bravo
Level 1
Level 1

Thanks in advance for your help, I'm hoping that this is a known issue since it occurs on several of our 4500 access swiches with redundant sup V and port channel uplinks (routed) to 6500 (core) switches, two to three times a day we experience the loss of EIGRP adjacencies on these port channels, the adjacencies are re-form inmediately which causes EIGRP reconvergence, table updates etc. There is nothing special about this configuration, 4500 sup V active has two 1Gb ports bundled (L3) and uplinked to "core 1 port channel #1, 4500 sup V standby is a duplicate of the active sup with two 1Gb ports bundled (L3) uplinking to "core 2 port channel #1. Nothing seems to trigger the flap, it just seems to happen without any good reason. Any help is appreciated.

3 Replies 3

Hello, Can you try removing the redundant port channell and keep only one port channel between the chassis. and see whether the problem

re occurs.

Regards

Harish

Paul Sellnow
Level 1
Level 1

Did you ever get a response to this issue? I am finding the same problem, only with no port channels. A few times a week, all the neighbors of this 4509 will time out and send Peer Termination messages, and then almost instantly the neighbors are rediscovered and adjacencies are reestablished.

dslice
Level 1
Level 1

What is the peer down reason in the log? Hold timer expired? Retry limit exceeded?

Sent from Cisco Technical Support iPad App

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: