cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
188
Views
0
Helpful
1
Replies

eigrp redistribution

sadam2006
Beginner
Beginner

dear all

if i am going to redistribute a routing protocol into eigrp, and i have a delay metric of 2ms how i am going to insert it in the redistribution command the dealy of the interface is a unit of 10-micros second as cisco tell, please help

1 REPLY 1

pkhatri
Advisor
Advisor

Hi,

The redistribute command for EIGRP takes a delay parameter in 10s of microseconds. Therefore, for a delay of 2ms, you need to set the delay parameter to 200. That means 200 x 10 microseconds, which gives you 2 seconds.

Paresh

PS> Pls do remember to rate posts.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: