Hi
We are using PRTG for monitoring bandwidth utilization. I noticed one of our etherchannels was using just above 100 mbit/s.
The etherchannel consist of 2 interfaces with 100 mbit/s SFP modules. In PRTG I can see that one of the interfaces is fully used. The other interface uses just about 5 mbit/s. I wanted to confirm this by using the " show etherchannel 1 detailed " command.
Can anyone tell me why it says 00 in load of 0 in no of bits?
Port-channel: Po1
------------
Age of the Port-channel = 92d:10h:23m:11s
Logical slot/port = 2/1 Number of ports = 2
GC = 0x00000000 HotStandBy port = null
Port state = Port-channel Ag-Inuse
Protocol = -
Port security = Disabled
Ports in the Port-channel:
Index Load Port EC state No of bits
------+------+------+------------------+-----------
0 00 Gi0/21 On 0
0 00 Gi0/24 On 0
Time since last port bundled: 92d:10h:23m:09s Gi0/24
