cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
188
Views
0
Helpful
1
Replies
Highlighted
Beginner

Ethernet traffic on 887va

Hi,

I have set up my network to pass ethernet (layer 2) traffic accross an adsl connection to another 887va router. this link is set up as a L2TP.

I have a PC at one end of the tunnel and a web ranger that operates at layer 2 level.

I can see the layer 2 traffic entering the router from the PC however it does not seem to go over the L2 tunnel to the other router.

Please can someone help? (Config files are attached)

I also need to know what debug codes I can enter to see if the data is being filtered and if so why?

the debug L2TP gives the following output:

L2TP Tunnel and Session Information Total tunnels 1 sessions 1

LocTunID   RemTunID   Remote Name   State  Remote Address  Sessn L2TP Class/

                                                           Count VPDN Group

2429948526 1313898432 routername    est   xxx.xxx.xxx.xxx  1     l2tp_default_cl

LocID      RemID      TunID      Username, Intf/      State  Last Chg Uniq ID  

                                 Vcid, Circuit                                 

2707157308 3583248854 2429948526 10, Vp2              est    06:41:26 1    

Many thanks,

Danny

1 REPLY 1
Hall of Fame Master

Re: Ethernet traffic on 887va

Already discussed in another thread:

https://supportforums.cisco.com/thread/2215735

Please avoid posting duplicates.

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards