Flexconfig EIGRP setup on Sourcefire 2130

[0rsnaric]

Does anybody have a configuration example for setting up EIGRP on the Sourcefire 2130? Preferably via FDM, and not FMC.

All of the Cisco docs I have found just go over generic flexconfig setups. Nothing specific to EIGRP.

Thanks!

[balaji.bandi · Accepted solution]

i was not used FDM for Long we use most of time only FMC

but as per document :

EIGRP

FlexConfig

Configure EIGRP using FlexConfig objects from the Device > Advanced Configuration page.

check if that works

https://www.cisco.com/c/en/us/td/docs/security/firepower/660/fdm/fptd-fdm-config-guide-660/fptd-fdm-routing.html

[0rsnaric]

Thank you.

This ended up being nothing more than a typical eigrp setup reduced to variables and templates.

No idea why they are pushing template based networking to smaller shops. I have no need to deploy this config to multiple devices...just one.