cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
8146
Views
0
Helpful
1
Replies

flow control on gigabitethernet router cisco 2911

gevangelista
Beginner
Beginner

Good morning,

I've a problem with a router 2911 (IOS 151-2.T1.bin).

On gigabitethernet 0/0 with  command sh interface.... is see  this line

output flow-control is XON, input flow-control is XON

On the other gigabitethernet  with the same command  I see

output flow-control is unsupported, input flow-control is unsupported

How it's possible to modifiy  the gigabitethernet to have   output flow-control is unsupported, input flow-control is unsupported?

Thanks in advance

regards

giancarlo

1 Accepted Solution

Accepted Solutions

Michael Muenz
Contributor
Contributor

Try this one:

https://supportforums.cisco.com/thread/2027655

Michael

Please rate all helpful posts

Michael Please rate all helpful posts

View solution in original post

1 Reply 1

Michael Muenz
Contributor
Contributor

Try this one:

https://supportforums.cisco.com/thread/2027655

Michael

Please rate all helpful posts

Michael Please rate all helpful posts
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: