I have a router with the following configuration and i am not seeing any NAT Translation can you please let me know where is the mistake.
The inside interface is Gigabit Ethernet 2.
I am natting 126.96.36.199 to 10.0.1.142
ip address 192.168.247.29 255.255.255.252
ip nat outside
tunnel source 10.0.0.252
tunnel destination 188.8.131.52
ip address dhcp
ip nat inside
ip nat pool LAN-NAT 184.108.40.206 220.127.116.11 prefix-length 24
ip nat inside source route-map GRE-NAT pool LAN-NAT
route-map GRE-NAT permit 10
match ip address office22
ip access-list extended office22
permit ip host 10.0.1.142 any
I had tested this statement before I was able to see NAT translations coming in but when traffic came from instance back to Internet it was not NAtting.
That is the reason I tried this different config it was not doing any translations
I think this is something to do with tunnel interface NAT
The NAT configuration I have given is correct, so it is some other issue - such as a lack of understanding of how your environment works.
Where does this tunnel go to? Is your Internet actually delivered over this tunnel? Do you have a default route pointing to 192.168.247.30?
Perhaps try posting your whole config.