Ok, let me make sure I get this correct.
Is that 'show run int vlan 333' from the Switch or from R1?
If (interface vlan 333) is from R1, can you post the results from 'show int vlan333' ?
Ok, Cool. So on R1, there is a physical port that is connected to this switch. On R1, can you post the results from 'show run int X' where X is the port on Router 1 that is going to this SW.
Show run int gi0/1
no ip address
ip flow ingress
ip flow egress
Here is the config on the switch that it hooks into as well:
description CISCO2911 Gig 0/1
switchport access vlan 141
switchport trunk encapsulation dot1q
switchport mode trunk
srr-queue bandwidth share 10 10 60 20
srr-queue bandwidth shape 10 0 0 0
mls qos trust cos
auto qos voip trust
rmon collection stats 1 owner PMmonitor
rmon collection history 1 owner PMmonitor buckets 50 interval 1800
So when it gets to R1, it's going to do a route lookup, and obviously take the default route, since there is no default route.
On Gi0/1, on R1, configure the IP address of 192.168.20.x, X will be some number that you want to use. Once this happens, it will become a directly connected route.
On R1, after you do this, you will see 192.168.20.0 255.255.255.0, and it will ARP out for any host on 192.168.20.x/24.
Is this switch for testing purposes?
Its not for testing purposes but I can play with it a little. The swtich is a 3560 and routing is not currently enabled on it. Can I enable routing on the switch and then put a static route on the router?
Ip route 192.168.20.0 255.255.255.0 via 192.168.20.200?
Disregard last post. I created the interface and it is now routing correctly. I really appreciate all of your help on this issue.
Thank you very much.