06-23-2010 08:42 PM - edited 03-04-2019 08:52 AM
Problem with GRE Tunnel:
I keep getting tunnel 0 up down, and there is no route to the destination, even though I put in a static route.
Message was edited by: kehagen Thanks guys. Basically I fixed it by fixing the ip connectivity between the two routers. Your questions triggered me to look in the right direction.
06-23-2010 10:33 PM
Hi
Are you able to ping the tunnel destination and traceroute. post the sh ip route if possible
HTH
Hitesh Vinzoda
Pls rate useful posts
06-23-2010 10:38 PM
Hi,
can you do an extended ping between the two loopback addresses (i.e. ping 128.8.8.8 with source 129.9.9.9 )? If not, you may need to add a static route for them over the serial interface.
HTH,
Marcel
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide