06-15-2007 11:47 PM - edited 03-03-2019 05:28 PM
Dear All,
I had switch cisco ws-c6509-E and have module ws-x6148A-GE-TX 48-port 10/100/1000 Base-TGE.On port g4/9 after i
shut down interface and no shut agian,it show message below:
HQ-6509(config-if)#int g4/9
HQ-6509(config-if)#shu
HQ-6509(config-if)#no shut
HQ-6509(config-if)#
00:44:03: %PM-SP-4-ERR_DISABLE: diagnostics error detected on Gi4/9, putting Gi4/9 in err-disable state
00:44:03: %PM-SP-STDBY-4-ERR_DISABLE: diagnostics error detected on Gi4/9, putting Gi4/9 in err-disable state
HQ-6509(config-if)#
what's going on?
Note:On port Gi4/9 connect to my pc,don't
link connection.
Best Regards,
join
06-16-2007 12:10 AM
Hi,
AFAIK there is a physical error on this port, as the diagnostics provide hardware-specific fault-detection.
HTH,
Mohammed Mahmoud.
06-16-2007 01:47 AM
Dear Mohammed ,
This problem,Can i fix it by myself?
Or need to send to factory?
Best Regards,
Join
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: