cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
674
Views
0
Helpful
2
Replies

have problem switch 6509

join_sn09
Level 1
Level 1

Dear All,

I had switch cisco ws-c6509-E and have module ws-x6148A-GE-TX 48-port 10/100/1000 Base-TGE.On port g4/9 after i

shut down interface and no shut agian,it show message below:

HQ-6509(config-if)#int g4/9

HQ-6509(config-if)#shu

HQ-6509(config-if)#no shut

HQ-6509(config-if)#

00:44:03: %PM-SP-4-ERR_DISABLE: diagnostics error detected on Gi4/9, putting Gi4/9 in err-disable state

00:44:03: %PM-SP-STDBY-4-ERR_DISABLE: diagnostics error detected on Gi4/9, putting Gi4/9 in err-disable state

HQ-6509(config-if)#

what's going on?

Note:On port Gi4/9 connect to my pc,don't

link connection.

Best Regards,

join

2 Replies 2

mohammedmahmoud
Level 11
Level 11

Hi,

AFAIK there is a physical error on this port, as the diagnostics provide hardware-specific fault-detection.

HTH,

Mohammed Mahmoud.

Dear Mohammed ,

This problem,Can i fix it by myself?

Or need to send to factory?

Best Regards,

Join

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: