cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
332
Views
0
Helpful
0
Replies
Highlighted
Explorer

Help with OER configuration

I have 3 routers: R1 is master and R2 and R3 are border routers. Subnet 10.10.1.0/24 is inside and subnet 10.10.100.0/24 is outside. R1 has OSPF with R2 and R3. R2 and R3 have equal cost OSPF routes to 10.10.100.0/24. R2 and R3 are directly connected but not running routing in between.

I want to have HTTP from 10.10.1.0/24 to 10.10.100.0/24 exit from R2 and FTP from 10.10.1.0/24 to 10.10.100.0/24 exit from R3. Here is the config on the master but it doesn't seem to be working. Nothing is showing in "show oer master policy" or "show oer master active-probe".

(key-chain, internal interfaces, external interfaces, etc are not shown here. 10.10.100.1 is the default gateway of 10.10.100.0/24)

If someone has a working OER configuration with policies of some type, I very much like to look at it. I have not seen one so far.

Master#

ip access-list extended HTTP

permit ip 10.10.1.0 0.0.0.255 10.10.100.0 0.0.0.255 eq http

ip access-list extended FTP

permit ip 10.10.1.0 0.0.0.255 10.10.100.0 0.0.0.255 eq ftp

oer master

mode route control

mode monitor active

oer-map HTTP 10

match traffic-class access-list HTTP

set mode select-exit good

set resolve utilization priority 1 variance 25

set resolve range priority 2

set active-probe echo 10.10.100.1

oer-map FTP 10

match traffic-class access-list FTP

set mode select-exit good

set resolve utilization priority 1 variance 25

set resolve range priority 2

set active-probe echo 10.10.100.1

Everyone's tags (2)
CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards